Amada LASER PDF's

[mie]

LASER

Altair

AltairII Foundation And Levelling
http://www.amada.com/support/lasers/alt ... d_prep.pdf
AltairII Pre-install Guide
http://www.amada.com/support/lasers/altair/Altr2_pi.pdf
AltairIII User Pre-Installation Guide
http://www.amada.com/support/lasers/alt ... nstall.pdf

Apelio

Apelio III 2510V Pre-installation Guide
http://www.amada.com/support/lasers/ape ... 10_pi3.pdf
Apelio III 357V, 367V Pre-installation Guide
http://www.amada.com/support/lasers/ape ... 367_pi.pdf

EML

EML Series Pre Install Manual
http://www.amada.com/support/lasers/eml ... 4-1-08.pdf
EML Series Pre Install Manual - Spanish
http://www.amada.com/support/lasers/eml ... 4-1-08.pdf

FOL
FOL3015NTPre-installation Guide
http://www.amada.com/support/lasers/fol ... 202006.pdf
SPANISH FOL3015NT Pre-installation Guide
http://www.amada.com/support/lasers/fol ... 202006.pdf

FO
FO-3015 Laser Series Pre-installation Guide
http://www.amada.com/support/lasers/gem ... nstall.pdf
FO-3015NT Laser Series Pre-installation Guide
http://www.amada.com/support/lasers/gem ... _30-08.pdf
FO-4020NT Laser Series Pre-installation Guide
http://www.amada.com/support/lasers/gem ... _30-08.pdf

Pulsar
PulsarA4-NT 1212 & 2415 Pre-Installation Guide
http://www.amada.com/support/lasers/pul ... -28-08.pdf

Theta
Theta LC3015 User Pre-Installation Guide
http://www.amada.com/support/lasers/the ... 20P-I1.pdf

Quattro
Quattro Pre-Installation Guide
http://www.amada.com/support/lasers/qua ... nstall.pdf

[jbaker]

I have an FO3045NT. It is extremely important to do something that Amada may not clearly tell you to do. If you're going to cut anything thicker than 1/8" material you must hook up an "evaporator/vaporizer". We did not and although Amada rose to the occasion and took care of the problem quickly at no cost to us, we lost a lot of production time. The machine is made in a way that it can easily be severely damaged if nitrogen gas comes into the machine faster than it can be vaporized. It is imperative to speak with your gas supplier and specify the proper model vaporizer and find out its total cost including hookup. I strongly suggest that you size the vaporizer to assume that you'll be cutting the thickest material the machine is able to cut and assume it's aluminum or stainless. Otherwise, if your product mix changes even on one job, you risk losing the machine.